Lcd Module; Open Lcd Module - Toshiba Satellite A500 Service Manual

4.24 LCD Module

4.24 LCD Module

NOTE: ICs are fragile. Use extreme care not to apply pressure to the ICs along the
edges of the LCD module.
NOTE: Dispose of used LCD panels (fluorescent (FL) tubes) as required by local
ordinances or regulations.
NOTE: The LCD/FL cable must be carefully peeled away before disconnecting it from the
module.
4.24.1

Open LCD module

Removing the LCD module
Remove the LCD module according to the following procedures and Figures 4-39, 4-40.
1. Peel off the two rubber sheets from LCD hinge.
NOTE: Don't touch the double tape of rubber sheet surface for keep double tape
surface clean and adhesive while remove the rubber sheet from the LCD hinge.
2. Remove two M2.5x4 black flat head screws on each side securing the LCD bracket.
3. Carefully tilt the LCD module toward you.
4. Remove three M2x3 black flat head screws on each securing the LCD bracket.
5. Remove the LCD brackets.
6. Turn the LCD upside down. Be sure to place it on a cushioned surface such as a foam
pad.
Satellite/Satellite Pro/A500/A505/A507/dynabook
4 Replacement Procedures
Maintenance Manual 4-65