Toshiba Satellite A500 Service Manual page 220

4 Replacement Procedures
Installing the LCD Module
NOTE: LCD/FL cable must be carefully peeled away before disconnecting it from the
module.
Install the LCD module according to the following procedures and Figures 4-39, 4-40.
1. Turn the LCD upside down.
2. Connect the LCD/FL cable to the LCD module connector.
3. Turn the LCD right side up.
4. Place the LCD bracket in the correct position and secure it with three M2x3 black flat
head screws on each side.
5. Please the LCD module in the correct position and secure it with three M2.5x4 black
flat heat screws on each side.
6. Stick the rubber sheet to hold the cable on LCD hinge.
NOTE: Don't touch the double tape of rubber sheet surface for keep double tape surface
clean and adhesive while using the rubber sheet to hold cable on hinge. If the rubber
sheet double tape has no adhesive or broken, please change a new rubber sheet
(V000939150).
CAUTION: When installing the LCD module, please follow below instruction:
When plug in LCD/FL cable into LCD module connector, need to plug horizontally. For
Sharp panel, if LCD/FL cable connector is not plugged horizontally, it may be damaged.
4-70
Manual
Satellite/Satellite Pro/A500/A505/A507/dynabook
4.24 LCD Module
Maintenance