Heart Rate Monitoring Devices - Diamondback 800 Series Owner's Manual

HEART RATE MONITORING DEVICES

Pulse Hand Grips (Standard)
The 800 Series products are heart rate controlled and come
standard with stainless steel pulse handgrips. To activate,
gently grasp both handgrips to obtain a heart rate reading.
(Note: It is recommended to wear a chest strap for Heart
Rate control program, as it is more accurate. If you wear a
chest strap and use hand grips at the same time for heart
rate monitoring purpose, please note the console will take
the measurement of the chest strap.)
Operating Tips:
If you are not getting a consistent reading while using the hand
pulse option, we recommend the following suggestions:
•
Make sure that the palms of the hands are touching
the contact area of each hand pulse grip.
•
Maintain an even pressure on the grips.
•
Do not hold the hand pulse grips too tightly.
Chest Strap (Standard)
The 800 Series products are equipped a built-in receiver and a
chest strap for your heart rate monitoring. To get an accurate
reading using these devices, you will need to be within three
feet of the console, and a minimum of four feet from others
using a heart rate monitoring device.
(Note: The transmitter may fluctuate erratically if you are too
close to other heart rate monitoring equipment or there is
other electronics near by, such as TV, Radio...)
The receiver of the wireless ECG system is built into the
console unit of the Diamondback Fitness 800 Series products.
While using heart rate control modes, the computer monitors
the exact measurement of and control over the activity if the
heart. Heart rate frequency is displayed while the computer
continually compares heart rate to the preprogrammed
personal data. The computer adjusts the wattage to maintain
heart rate at the preprogrammed level.
How to Wear Your Sensor/ Transmitter
1. Buckle one end of the chest strap onto the
transmitter.
2. Adjust the band length so that the fit is snug, but not
too tight.
3. Buckle the other end of the chest strap onto the
transmitter.
4. Center the transmitter on your chest below the
pectoral muscle (breasts).
5. Stretch the transmitter away from your chest and
moisten the conductive electrode strips located next
to the buckles with water.
(Note: The transmitter is on automatically when being worn.
It is off when it is not connected to your body. However, as
moisture may activate the transmitter, thoroughly dry the
transmitter to prolong battery life.)
8 0 0 S E R I E S O W N E R ' S M A N U A L
13