Dishwasher Efficiency Tips; Cycle Selection Chart - KitchenAid KUDS01IJ Use And Care Manual

Dishwasher Efficiency Tips

Hot water dissolves and activates the dishwashing detergent.
Hot water also dissolves grease on dishes and helps glasses dry
spot-free. For best dishwashing results, water must be at least
120°F (49°C) as it enters the dishwasher. Loads may not wash as
well if the water temperature is too low.
To check water temperature
1. Run hot water at the faucet closest to your dishwasher for at
least 1 minute.
2. Place a candy or meat thermometer in a glass measuring
cup.
3. Check the temperature on the thermometer as the water is
running into the cup.
4. If the water temperature at the faucet is below 120°F (49°C),
have a qualified person raise the water heater's thermostat
setting.
To save water, energy and time, do not rinse dishes before
putting them into the dishwasher.
Use the Normal cycle whenever possible. This cycle uses
less hot water and energy than other cycles.
Use a delay feature (on some models) to run your dishwasher
during off-peak hours. Local utilities recommend avoiding
heavy usage of energy at certain times of day.
During the summer, run your dishwasher at night. This
reduces daytime heat buildup in the kitchen.
Use an air dry, or an energy-saving dry option whenever
possible. Allow longer drying times (overnight) when using
these options. Use a rinse aid to improve drying.
Use cycles or options that add extra heat to the wash or rinse
portion of the cycle only when needed.
Run your dishwasher with full loads. Run a rinse cycle after
meals until the dishwasher is full.
12

Cycle Selection Chart

Select the wash cycle and options desired. Or press START to
repeat the same cycle and options as the previous cycle.
NOTE: If the last cycle you completed was a rinse cycle, the
dishwasher will run the last full wash cycle and options that you
selected when you press Start.
If the power is off or the door is open for an extended period
of time, the Start button memory will default to the Normal
cycle with heated drying.
If you do not run the dishwasher daily, close the door to
maintain memory.
A " " shows what steps are in each cycle.
Temperatures indicate where extra heat is added.
Water usage is shown in U.S. gallons/liters.
This model meets the ENERGY STAR
efficiency.
Cycle time includes dry time. An asterisk ( * ) by the cycle time
indicates the cycle time might be longer depending on the
temperature of the water entering the dishwasher. The cooler the
water, the longer the cycle time. If the water is already hot
enough, the cycle time will be as shown.
Use this cycle for hard-
to-clean, baked-on
cookware and harder than
normal water conditions.
Soil Pre- Main Rinse
Level Wash Wash
Sensed
130°F 145°F
Heavy
(54°C) (63°C)
130°F 145°F
Light
(54°C) (63°C)
Use this cycle for loads with
normal amounts of food
soil. (The energy-usage
label is based on this cycle.) Use both detergent
Soil Pre- Main Rinse
Level Wash Wash
Sensed
140°F
Heavy
(60°C)
120°F
Light
(49°C)
guidelines for energy
®
Use both detergent
dispenser
sections.
Rinse Final Dry Time
Heated (min)
Rinse
98*
160°F
(71°C)
91*
160°F
(71°C)
dispenser
sections.
Rinse Final Dry Time
or Heated (min)
Purge† Rinse
94*
140°F
(60°C)
79*
140°F
(60°C)
Water
Usage
(gal/L)
8.8-
10.4
/33-39
6.9/26
Water
Usage
(gal/L)
7.1-8.4
/27-32
5.5/21