Replacement Of Batteries - Vivax ACP-18CH50GEEI Service Manual

CLOCK :
9
Pressing CLOCK button,
above 2 seconds increases or decreases the time by 1 minute every 0.5 second and then by 10 minutes every 0.5 second. During
blinking after setting, press CLOCK button again to confirm the setting, and then
X-FAN:
10
Pressing X -FAN button in COOL or DRY mode,the icon
order to dry the indoor unit even though you have turned off the unit.
After energization, X-FAN OFF is defaulted. X-FAN is not available in AUTO, FAN or HEAT mode.
TEMP:
11
Press this button, you can see indoor set temperature, indoor ambient temperature on indoor unit's display. The setting on remote
controller is selected circularly as below:
When selecting " " with remote controller or no display, temperature indicator on indoor unit displays set temperature; When
selecting " " with remote controller, temperature indicator on indoor unit displays indoor ambient temperature; 3s later or within 3s
it receives other remote control signal that will return to display the setting temperature.
Caution:
•This model hasn't outdoor ambient temperature display function. While remote controller can operate "
set temperature.
• It's defaulted to display set temperature when turning on the unit.
• Only for the models with temperature indicator on indoor unit.
TURBO:
12
Press this button to activate / deactivate the Turbo function which enables the unit to reach the preset temperature in the shortest
time. In COOL mode, the unit will blow strong cooling air at super high fan speed. In HEAT mode, the unit will blow strong heating air
at super high fan speed.
SLEEP:
13
Press this button to go into the SLEEP operation mode. Press it again to cancel this function. This function is available in COOL,
HEAT (Only for models with heating function) mode to maintain the most comfortable temperature for you.
LIGHT:
14
Press LIGHT button to turn on the display's light and press this button again to turn off the display's light. If the light is turned on ,
is displayed. If the light is tunrned off,
Combination of "+" and "-" buttons: About lock
15
Press "+ " and "-" buttons simultaneously to lock or unlock the keypad. If the remote controller is locked,
case, pressing any button,
Combination of "MODE" and "-" buttons:About switch between Fahrenheit and Centigrade At unit OFF, press "MODE" and "- "
16
buttons simultaneously to switch between

Replacement of Batteries

1.Remove the battery cover plate from the rear of the remote controller.
(As shown in the figure)
2.Take out the old batteries.
3.Insert two new AAA1.5V dry batteries, and pay attention to the polarity.
4. Reinstall the battery cover plate.
Notes:
●When replacing the batteries, do not use old or different types of batteries.
Otherwise, it may cause malfunction.
●If the remote controller will not be used for a long time,
please remove batteries to prevent batteries from leaking.
●The operation should be performed in its receiving range.
●It should be kept 1m away from the TV set or stereo sound sets.
●If the remote controller does not operate normally, please take the
batteries out and reinsert them after 30 seconds. If it still can't operate
properly, replace the batteries.
blinks. Within 5 seconds, pressing + or - button adjusts the present time. Holding down either button
no display
disappears.
blinks three times.
and .
will be constantly displayed.
is displayed and the indoor fan will continue operation for 2 minutes in
"and indoor unit displays
is displayed. In this
Sketch map for
replacing batteries