Mix Mode - Tascam DR-40 Reference Manual

4 – Recording
If you record again using the same playback file (File-A),
the name of File-B above is changed to the file name below
(File-C), and the new recording file is given the File-B file
name.
TASCAM_0004V34t1.WAV
File-C:
If you record one more time using the same playback file
(File-A) (and File-B and File-C above are saved), the file name
for File-B changes as shown below, with the number at 6
increased by one, and the new recording file given the File-B
file name.
TASCAM_0004V34t2.WAV
File-D:

8 MIX mode

Playback file
TASCAM_0004S12.WAV
File-A:
The newly recorded file (recorded with the playback signal
(File-A))
TASCAM_0005S12.WAV
File-E:
54
TASCAM DR-40
If you record again using the same playback file (File-A), the
file name of the new recording will be as follows.
TASCAM_0006S12.WAV
File-F:
In this mode, each time you record with the same playback
file, the number in item 2 increases by one for the name of
each new file.
1: Set with the item on the
WORD
2: Recording file base number
3: "S" is the source file and "V" is the virtual file
4: Assigned channels ("12" is channels 1/2 and "34" is
channels 3/4)
6: Backup number in the virtual file
NOTE
• In OVERDUB SEPARATE mode, the base number of the
recording file and "S12" are added to the file name of the
playback file.
• If writing files copied from elsewhere is not possible, enable
writing using a computer, for example.
screen
FILE NAME