Displays In The Partitioning Master Mode - GE NX-148E Installation And Setup

8d. DISPLAYS IN THE PARTITIONING MASTER MODE
ARMED AND READY STATUS
The LCD screen will display the Armed and Ready status of ALL eight (8) partitions if any or all of the
areas is armed or not ready. Refer to the following examples:
Ready 12345678
Armed 12-4-678
System Ready
Type code to arm
ARMING AND DISARMING MULTIPLE PARTITIONS
Disarm º
12-45-78
--3 67- Arm
TOP LINE OF DISPLAY = disarmed areas to which this code has access
BOTTOM LINE OF DISPLAY = areas that are armed
Table 8-1 List of Possible Conditions
Blank
Blank
Dash (-)
Dash (-)
Flashing
Dash (-)
Dash (-)
Flashing
Area #
Dash (-)
Dash (-)
Area #
To disarm all of the areas, press •.
To arm all of the areas, press –.
To toggle a single area between the armed and disarmed conditions, press
example, if Area 4 is armed,
To control the individual areas, refer to the following section "Operating Individual Areas in the Multi-
Partition Mode".
20
All 8 areas are Ready, and areas 3 and 5 are disarmed.
Flashing number on the ready line = area is ready to be Force Armed.
Flashing number on the armed line = area is armed Instant.
ALL areas are disarmed and ready to arm.
To arm/disarm multiple partitions, enter a code that has arm/disarm
authority for ALL of the partitions to be armed/disarmed. A display
º
similar to the one on the left will appear on the LCD screen.
LCD DISPLAY
If area number is ....
will disarm Area 4. If Area 4 is disarmed,
CONDITION
Area Not Used or Authorized
Area Not Ready
Area Ready to Force Arm
Area Armed Instant
Area Disarmed & Ready to Arm
Area is Armed
[Area number]. For
will arm it.
LCD KEYPAD