Partitioned Systems Operation; Master Mode; Temporary" Master Mode; Lights In Partitioning Master Mode - GE NX-148E Installation And Setup

8. PARTITIONED SYSTEMS OPERATION

8a. MASTER MODE
The LCD keypad can be programmed to operate all the system partitions simultaneously. To set the
multi-partition mode, use the
question "Master keypad?"
8b. "TEMPORARY" MASTER MODE
[user code]
Press
assigned partition 60 seconds after a key press or 10 seconds without a key press. Press
8c. LIGHTS IN PARTITIONING MASTER MODE
#
ARMED will illuminate if ALL partitions are armed.
#
READY will illuminate if ALL partitions are "Ready". The ready light will flash if all areas are
Ready or Force armable.
#
FIRE will illuminate if ANY one area has a Fire condition. The fire light will flash if ANY area
has a Fire Trouble condition.
#
POWER will illuminate if the primary power is connected to the NX8-E control panel. It will
flash if the system has a low standby battery condition.
#
STAY will illuminate if ANY area has the stay light on.
#
CHIME will illuminate if ANY partition is in the "Chime" mode.
#
EXIT will illuminate if ANY area is timing an exit delay. It will flash if ANY area is in the last 10
seconds of an exit delay.
#
BYPASS will illuminate if ANY area has a zone bypassed.
#
CANCEL will flash during an abort delay time. If a code is entered followed CANCEL while
this light is flashing, all abortable reports will stop the communication process to the central
station. If a code is entered followed by CANCEL during or after an alarm report, the cancel
light will illuminate and remain constant until the central station has received the cancel
report.
#
SOUNDER will sound if ANY area has the sounder on. This includes Entry delay, Exit delay,
Chime, and Alarm.
LCD KEYPAD
function as described on page 10, and answer "YES" to the
to temporarily access the Master Mode. The keypad will revert back to its
#
to exit.
19