Fset Keypad Number And Partition - GE NX-148E Installation And Setup

OPT
1 NOT USED
2 SILENT KEYPAD?
3 DING DONG CHIME?
4 5 SEC. SILENCE?
5 ARMED ZONE INFO?
6 BEEP ON PANICS?
7 DISABLE SERVICE?
8 MASTER KEYPAD?
9 CUSTOM MESSAGE?
10 CLOCK?
11 CUSTOM MSG. LOCK?
12 SELECT AN OPTION: Programs special characteristics.
1=Display "Press r For Help"
2=Disable LED Extinguish on this keypad
3=On if PIN should be hidden when programming
4=On suppresses beeps when an RF transmission is lost
5-8=RESERVED (Do not program!)
6f. SET KEYPAD NUMBER AND PARTITION
ACTION
[program code]
[keypad number]
[partition number]
LCD KEYPAD
KEYPAD FEATURES
Enable Silent Keypad Option. If enabled, only the entry/exit and
sounder chime are silenced.
Enable Ding Dong Sound for Chime. If off, chime will be a single
tone. (Refer to NX control panel installation manual, location 40)
Enable Keypress Silence Option. Silences the pulsing keypad
sounder for 5 seconds when a key is pressed.
Enable Armed Zone Information. If on, the LCD keypad will display
faulted or bypassed zone information when the system is armed.
Enable Panic, Fire, and Medical Beeptone. Will sound a short beep
to verify that the keypress was accepted.
Suppresses the "Service" Message. This will not allow the "Service
Required" message to be displayed for any reason. If there is a
r
system trouble,
Enable Multi-partition Mode
Enable Custom Message Display
Enable Clock Display
Enable Custom Message Lock. Prevents over-writing the custom
message during keypad copy.
Prompts to "Please Enter Your Code".
Prompts for the keypad number.
The current keypad number will be displayed
in the lower right hand corner.
Prompts for the partition number.
The current partition will be displayed in the
lower right hand corner.
Automatically exits this mode.
will still show the "Service Required" menu.
RESULT
11