Partitioned Systems Operation; Lights In Partitioning Master Mode - GE NetworX NX-1192E User Manual

XX.

PARTITIONED SYSTEMS OPERATION

If your system is multi-partitioned and the keypad resides in one partition, your keypad
will provide the status of the zones in your partitioning by using the screen messages
described earlier in this manual.
temporarily access any partition (providing your code is authorized) within the system
and to perform functions in other partitions. Read this entire manual to help you
understand the different screen messages that will be displayed from your keypad.
X
À
NOTE:
will temporarily access the Master Mode. The keypad will revert back
to its assigned partition 60 seconds after a keypress, or 10 seconds without a keypress.

Press to exit.
XXI.

LIGHTS IN PARTITIONING MASTER MODE

„
ARMED will illuminate if ALL partitions are armed.
„
READY will illuminate if ALL partitions are "Ready". The ready light will flash if all
areas are Ready or Force armable.
„
FIRE will illuminate if ANY one area has a Fire condition. The fire light will flash if
ANY area has a Fire Trouble condition.
„
POWER will illuminate if the primary power is connected to the NX-8 control panel.
It will flash if the system has a low standby battery condition.
„
STAY will illuminate if ANY area has the stay light on.
„
CHIME will illuminate if ANY partition is in the "Chime" mode.
„
EXIT will illuminate if ANY area is timing an exit delay. It will flash if ANY area is
in the last 10 seconds of an exit delay.
„
BYPASS will illuminate if ANY area has a zone bypassed.
„
CANCEL will flash if ANY partition is in an abort delay time. If a code is entered
followed by the [CANCEL] key during or after an alarm report, the cancel light will
illuminate and remain constant until the central station has received the cancel
report.
„
SOUNDER will sound if ANY area has the sounder on. This includes Entry delay,
Exit delay, Chime, and Alarm.
v
This system is
v
is not partitioned.
The Master Mode of operation allows you to
21