Control Commands - Theben PresenceLight 180A-KNX series Operating Manual

8. Control commands

The following control commands are available with the management remote
control SendoPro 868-A:
Programming mode
Teach-in channel A
Master/Slave?
Switching light
Test presence
Test lighting
Restart
Activating the programming mode
The actual measured brightness value is applied to the brightness
level channel A.
Transfer is made to current active brightness set point value. That is,
if the alternative brightness set point value is switched to, the current
measured brightness value [lux] is transferred to the alternative
brightness set point value via the teach-in command.
The value transfer is not carried out if the measured brightness value
is outside the value range of the brightness set point value (displayed
via LED).
The operating mode master or slave can be determined using the
remote control. Is the request consistent with the setting in the
presence detector, does the detector confirm this with a flicker for 3
s. Is the request not consistent, the LED lights up briefly.
The switching output light can be switched on and off.
Select <On> or <Off> with the function keys.
See chapter 7.1 page 75
See chapter 7.2 page 77
The detector restarts. Setting values are retained.
GB
79