Test-Mode - Theben PresenceLight 180A-KNX series Operating Manual

If setting values for brightness <= 2.5 AND switch-off delay time light <= 2 min:
faster response to changes in actual brightness when in operating mode switching
of one lighting row.

7. Test-Mode

The PresenceLight has two test modes.
● Test presence, page 75
● Test lighting, page 77
The test mode can only be started with voltage.
7.1 Test presence
The test presence serves to test presence detection and parallel switching.
Activate
Terminate
LED display
channel status
On
- "Test presence on" with the management remote control SendoPro 868-A
- via bus object (33)
The test mode presence can always be activated.
With subsequent restart:
- Command "Test presence off" with the management remote control
SendoPro 868-A
- Loss of bus voltage
- Automatically according to the time set with the ETS
Without restart:
- Activation of test lighting with the management remote control SendoPro 868-A
Description
With movement (LED on) close channels A lighting and H presence.
GB
75