Start-Up; Programming Mode - Theben PresenceLight 180A-KNX series Operating Manual

5. Start-up

5.1 Settings
All settings are adjusted using ETS. See 'KNX handbook PresenceLight 180 KNX /
GB
PresenceLight 360 KNX' document (application description).
The management remote control SendoPro 868-A is optionally available for sup-
port during the installation. The SendoPro 868-A can be used to adjust and op-
timise parameters. In this respect, the SendoPro 868-A helps with setting up. A
range of alterable parameters is available for adjustment with the SendoPro 868-A
(see chapter 6 page 73). By means of control commands, the behaviour during in-
stallation can be changed via the SendoPro 868-A (see chapter 8 page 79).
5.2 Correction factor
The presence detector›s brightness actual values is adjusted to the room proper-
ties with the room correction factor and thus, the area under the presence detector
can be compared to the measured lux meter value.
See KNX handbook, application description

5.3 Programming mode

The programming mode can be set using the program button on the back of the
presence detector or via the management remote control SendoPro 868-A without
dismantling the presence detector.
5.4 Set device to original condition
The presence detector is supplied with a factory setting. This factory setting can
be restored as desired.
71