Alterable Parameters Via Remote Control - Theben PresenceLight 180A-KNX series Operating Manual

6. Alterable parameters via remote control

The following parameters can be adjusted and optimised via the management re-
mote control SendoPro 868-A for support during installation as well as servicing.

Parameter
Brightness level channel A light
Alternativ brightness level channel A light
6.1 Adjustment with the remote control
Parameters are sent to the presence detector via infrared with the SendoPro 868-
A. Changed parameters are immediately accepted and applied by the detector.
LED Description
Flickering during After pressing the send function on the management remote control, the pres-
3 sec ence detector displays correct receiving by flickering for 3 sec.
Lights up shortly The command/parameter sent from the management remote control via infrared
is rejected by the presence detector. The command is not valid. Check the
selected detector type and the sent parameters.
This adjustment of parameters does not change the settings
in ETS.
Level increase/decrease
Level increase/decrease
GB
Chapter /
Page
6.2 / 74
6.3 / 74
73