Appliance Vent Connection - Napoleon GDS50N Operating Instructions Manual

4.2.5 APPLIANCE VENT CONNECTION

Attach the adjustable pipe to the last section of rigid pipe.
A.
Secure with screws and seal.
Install the inner fl ex pipe to the appliance. Secure with 3 screws
B.
and fl at washers. Seal the joint and screw holes using the high
temperature sealant W573-0007 (not supplied).
Run a bead of high temperature sealant (not supplied) around
C.
the inside of the air intake collar. Pull the adjustable pipe a
minimum 2" into the air intake collar.
NOTE: Ensure that the sealant is not visible on the exterior pipes once installation is completed. An
optional decorative black band is available for this use. In the event that the venting must be disassembled,
care must be taken to reseal the venting.
#8 X 1/2"
SELF
DRILLING
SCREWS
2" OVERLAP
HIGH TEMPERATURE
SEALANT
28.3
23
W415-0098 / H / 03.19.12