Checking The Connections Of Leads - Pioneer SPH-DA120 Operation Manual

System settings
4 Touch the HOME button to display the
Top menu screen.
5 Touch the following keys in the follow-
ing order.
The "System" screen appears.
6 Touch [System Information].
7 Touch [Firmware Update].
The "Firmware Update" screen appears.
8 Touch [Continue] to display the data
transfer mode.
p Follow the on-screen instructions to finish
updating the firmware.
p This product will reset automatically after
the firmware update is completed if the up-
date is successful.
p When the firmware update starts, the
source is turned off and the Bluetooth con-
nection is disconnected.
p If an error message appears on the screen,
touch [Continue] to proceed and start the
recovery sequence.
Checking the connections
of leads
Check that the leads are properly connected
between this product and vehicle.
1 Touch the HOME button to display the
Top menu screen.
2 Touch the following keys in the follow-
ing order.
The "System" screen appears.
3 Touch [System Information].
4 Touch [Connection Status].
The "Connection Status" screen appears.
! GPS Antenna
Indicates the connection status of the GPS
aerial, the reception sensitivity, and from
how many satellites the signal is received.
Signal com-
Colour
munication
Orange Yes
Yellow Yes
p When the GPS aerial is connected to
this product, "OK" is displayed. When
the GPS aerial is not connected to this
product, "NOK" is displayed.
p If reception is poor, please change the
installation position of the GPS aerial.
! Positioning Status
Displays the positioning status (3D posi-
tioning, 2D positioning, or no positioning),
the number of satellites used for position-
ing (orange), and the number of satellites
whose signal has been received (yellow). If
signals from more than three satellites are
received, the current location can be mea-
sured.
= For details, refer to Positioning technol-
ogy on page 115.
! Illumination
When the headlights or small lamps of the
vehicle are on, "ON" is displayed. When the
small lamps of the vehicle are off, "OFF" is
displayed. (If the orange/white lead is not
connected, "OFF" appears.)
! Back Signal
When the gearstick is shifted to "R", the
signal switches to "High" or "Low". (One of
these is displayed depending on the
vehicle.)
Chapter
17
Used in posi-
tioning
Yes
No
85
Engb