Table of Contents
Advertisement
Setup
1. Unscrew tip and guard assembly
from gun.
2. Uncoil hose and connect one
end to gun. Use two
wrenches to tighten securely
3. Connect other
end of hose to
sprayer.
ti11456a
(LTS15, LTS 17)
NOTE: If hose is already connected, make sure connec-
tions are tight.
4. Turn OFF power switch.
5. Turn Pressure Control Knob
all the way left (counter-clockwise)
to minimum pressure.
313034H
Prime and Flush Storage Fluid
NOTE: To spray lacquers with the ProLTS 17 and
ProLTS 19, you must purchase lacquer conversion kit
256212, and follow priming procedure for oil-based
materials. The LTS 15 and LTS 17 units are not intended
for lacquers.
ti11978a
Before you use your sprayer for the first time or be-
gin a new spraying project, you need to prime the
sprayer and flush the storage fluid out of the spray-
er.
Oil- or Water-based Materials
•
When spraying water-based materials, flush the
ti11977a
system thoroughly with water.
•
When spraying oil-based materials, flush the sys-
tem thoroughly with mineral spirits or compatible,
oil-based flushing solvent.
•
To spray water-based materials after spraying
oil-based materials, flush the system thoroughly
with water first. The water flowing out of prime tube
ti9674b
should be clear and solvent-free before you begin
spraying the water-based material.
(ProLTS)
•
To spray oil-based materials after spraying
water-based materials, flush the system thoroughly
with mineral spirits or a compatible oil-based flush-
ing solvent first. The solvent flowing out of the prime
tube should not contain any water.
•
When flushing with solvents, ground pail and gun.
Read Grounding and Electric Requirements, page
7.
ti2810a
•
To avoid fluid splashing back on your skin or into
your eyes, always aim gun at inside wall of pail.
ti9344a
Setup
11
Hide quick links:
Advertisement
Table of Contents
