When Access Key Does Not Operate Properly; Hazard Warning Flasher - Subaru XV Crosstrek 2015 Owner's Manual

3-8
Instruments and controls/Hazard warning flasher
does not operate smoothly, stop
t h e o p e r a t i o n . C o n t a c t a
SUBARU dealer immediately.
. If the push-button ignition switch
does not illuminate even when
the instrument panel illumination
is turned on, have the vehicle
inspected at a SUBARU dealer.
. If the vehicle was left in the hot
sun for a long time, the surface of
the push-button ignition switch
may get hot. Be careful not to
burn yourself.
NOTE
. The push-button ignition switch can-
not be switched to OFF
select lever is in a position other than
P .
. When operating the push-button
ignition switch, firmly press it all the
way.
. If the push-button ignition switch is
pressed quickly, the power may not
turn on or off.
. If the indicator light on the push-
button ignition switch flashes in green
when the push-button ignition switch is
pressed, steering is locked. When this
occurs, press the push-button ignition
switch while turning the steering wheel
left and right.
Battery drainage prevention func-
tion
When the push-button ignition switch is
left in the ACC or ON position for
approximately 1 hour, the push-button
ignition switch will be automatically
switched to OFF to prevent the battery
from going dead. This function is activated
when the select lever is in the P position.
When access key does not
operate properly
Refer to Access key
not operate properly
when the

Hazard warning flasher

if access key does
9-18.
Type A
Type B
The hazard warning flasher is used to
warn other drivers when you have to park