Table of Contents
Advertisement
3-30
Instruments and controls/Warning and indicator lights
Security indicator light
This indicator light shows the status of the
alarm system. It also indicates operation
of the immobilizer system.
Alarm system
It blinks to show the driver the operational
status of the alarm system. For detailed
information, refer to Alarm system
27.
Immobilizer system
The security indicator light starts blinking
in the following conditions.
For models with keyless access with
push-button start system :
. Immediately after the push-button igni-
tion switch is turned to the OFF position.
. Immediately after the driver s door is
opened or closed when all of the following
conditions are met.
The push-button ignition switch is in
the ON or ACC position.
The access key is outside the
vehicle.
The engine is not running.
In the event that an unauthorized
key is used (for example, the key is
unregistered or the ID code does not
match), the power is not switched to
ON and the security indicator light
continues blinking.
For models without
with push-button start system :
. Approximately 60 seconds after the
ignition switch is turned from the ON
position to the ACC or LOCK position.
. Immediately after the key is pulled out.
2-
If the indicator light does not blink in the
above conditions, it may indicate that
immobilizer system may be malfunction-
ing. Contact your nearest SUBARU dealer
immediately.
In the event that an unauthorized key (for
example, an unauthorized duplicate) is
used, the security indicator light illumi-
nates. For details about the immobilizer
system, refer to Immobilizer
NOTE
. The security indicator light remains
off in the following conditions. This is
normal and does not indicate a mal-
function.
while the engine is running
for approximately 60 seconds
after the ignition switch is turned
from the
ON
ACC or LOCK (off) position
. Even if the security indicator light
blinks irregularly or its fuse blows (the
light does not blink if its fuse is blown),
the immobilizer system will function
keyless access
normally.
Select lever/gear position in-
dicator (CVT models)
2-3.
Type A
1)
Upshift indicator
2)
Downshift indicator
3)
Select lever/gear position indicator
position to the
Advertisement
Chapters
Table of Contents
