Oven Light; Storage - Rangemaster Elite SE 110 Dual Fuel User's Manual & Installation Instructions

Fig.2.37
Left-hand side
Fig.2.38
Left-hand side
Fig.2.39
Fig.2.40
Make sure the inner
rail is forwards
Fig.2.41
Right-hand side
Right-hand side
12
Other Uses
The Handygrill and pan can also be used for roasting.
Remove the trivet from the pan and position the rack at the
height of the centre of the oven. Use the fan or conventional
oven settings and follow the guide time in the cooking chart
for roasting.
Only use the supplied pan in the Handygrill rack – any other
vessel could be unstable.
Fitting the Handygrill
Line up the ends of the Handygrill rack with a pair of holes in
the mounting brackets on the oven door (Fig.2.37).
Slide the ends into both uprights at the same time (Fig.2.38).
Hook the rack on to the uprights.

Oven Light

The oven light comes on as soon as the thermostat is turned
on.
If the oven light fails, turn off the power supply before
changing the bulb. See the 'Troubleshooting' section for
details on how to change the bulb.

Storage

The bottom drawer is for storing oven trays and other
cooking utensils.
It can get very warm, so do not store anything in it that may
melt or catch fire. Never store flammable materials in the
drawer. This includes paper, plastic and cloth items, such as
cookbooks, plastic ware and towels, as well as flammable
liquids. Do not store explosives, such as aerosol cans, on or
near the appliance.
Flammable materials may explode and result in fire
n n
or property damage.
The drawer can be removed completely for cleaning, etc.
To Remove the Drawer
Pull the drawer right out.
Push the ends of the plastic clips – down on the left-hand
side, up on the right-hand side – to release the catches
holding the drawer to the side rails (Fig.2.39). At the same
time pull the drawer forwards and away from the side rails.
For safety's sake push the drawer rails back out of the way.
To Replace the Drawer
To replace the drawer in the cooker, pull the side rails fully out
(Fig.2.40).
Carefully move the drawer back between the rails and rest it
on the side rails (Fig.2.41).
Push the drawer back until the clips click into place.