Table of Contents
Advertisement
1. Remove the "Cover Top" Block. Refer to
2. Remove the 4 screws (BH, M3x4 (NI)) and detach the "Unit, Ribbon" by lifting it upwardly. At
this time, disconnect 1 connector (J102) from the "Unit, Ribbon".
J102
Notes on reassembling:
• Seat the cable (J102) on the "Plate Ribbon Cable Stay" as shown below.
• When assembling the "Unit, Ribbon", be sure that it is securely seated on the main body.
The 2 protrusions on the bottom of the "Unit, Ribbon" are naturally inserted in the respective
holes "A" of the main body for positioning the "Unit, Ribbon".
Unit, Ribbon
Plate Ribbon Cable Stay
J102
A
Disassembly, Reassembly and Lubrication
"3-6-1(1) Removing the "Cover Top"
BH, M3x4 (NI)
3-13
Block".
CL-S6621
Advertisement
Chapters
Table of Contents
