Connecting The Hardware - Axis 5800+ Mobile Quick Installation Manual

AXIS 5800+ Mobile

Connecting the Hardware

1. Make sure that the printer is switched off and that the power supply is disconnected from
the AXIS 5800+ Mobile.
2. Locate the serial number, found on the underside label of the AXIS 5800+, and write it
down. Example: Ser. No. 00408C1802FB
3. Connect your printer(s) to the print server's LPT1 or LPT2 port using a printer cable. Make
Bluetooth
sure the
4. Connect your AXIS 5800+ to your network (Ethernet Connector), using a twisted pair
category 5 cable.
5. Switch on your printer(s) and make sure it is ready for use.
6. Connect the power supply to the AXIS 5800+. The Network Indicator will start flashing
when the print server is correctly connected to the network.
7. Wait 1 minute and press the test button once. A test page will be printed on the
connected printer, keep it handy during the installation. The test page will show the IP
address of the print server.
Bluetooth Antenna
Power Indicator
AXIS Network Product CD
The AXIS Network Product CD includes AXIS Utilities Software, Product Software, White
Papers, User Documentation, etc. It is compatible for use within all of the supported Axis
computing environments.
Notes:
• All documents presented on the CD are in PDF format.
• If Adobe Acrobat Reader 3.0 or higher is not installed on to your system, you can download
Acrobat Reader from the AXIS Network Product CD or Adobe's web site at
http://www.adobe.com.
antenna is pointing upwards.
LPT1
Connecting the Hardware
LPT2
Power Supply Connector
Network Indicator
Ethernet Connector
10 base T & 100 base TX
Test Button
5