Troubleshooting - Pioneer DVD-V7200 Operating Instructions Manual

Troubleshooting

Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with this component,
check the items below. Sometimes the trouble may lie in another component. Inspect the other components and electrical appliances
being used. If the trouble cannot be rectified even after exercising the checks listed below, ask your nearest PIONEER authorized
service center or your dealer to carry out any repair work.
Operation
1. The disc comes back out
even when the disc table is
closed
2. Playback is impossible
3. Picture disturbance during
playback
4. When recorded to a VCR
there is disturbance in the
playback picture
5.
6. Picture playback stops and
the operation button can not
be used
Remote control
7. Remote control operation is
not possible
8. Improper operation of TV set
occurs
Audio 9. Audio is missing or is
distorted
10. Noticeable difference in
DVD and CD volumes
Caution: Abnormal functioning of this unit may be caused by static electricity or other external interference. To restore normal operation,
unplug the AC power cord then plug it in again.
Troubleshooting
52
<VRB1185>
Symptom
÷ The disc is dirty or warped
÷ The disc is not placed properly on the disc table
÷ Region number on disc and player do not match
÷ Condensation has formed inside the player
÷ This player plays the NTSC format only
÷ This player is compatible with MacroVision System copy
÷ This player is compatible with analog copy protect
÷ The selected function does not operate for that disc
mark appears on screen
÷ First stop the disc (press the 7 button), then start
÷ The front-panel EXT CONT jack is connected
÷ The remote control is too far from the player, or the
÷ The batteries are low
÷ A number is input without pressing the FUNCTION
÷ Some TVs that have wireless remote control functions
÷ The digital output setting is set to 96KHz
÷ The connection plugs are not inserted fully into the
÷ The connection plug or terminal is dirty
÷ Audio cable is connected incorrectly
÷ Connection is made to the stereo amplifier's PHONO
÷ The pause mode is engaged
÷ Stereo amplifier is connected incorrectly
÷ There may be a difference in volume between a CD
Possible causes
(not PAL or SECAM format)
guard. Some discs include a copy prevention signal
thus when this type of disc is played back, stripes etc.,
may appear on some sections of the picture
(depending on TV model - this is not a malfunction)
technology copy guard. Some discs include a copy
prevention signal thus the copy guard system
prevents proper playback
playback again
angle with the remote sensor is too wide.
button first
may not operate properly with this remote control
(digital output is prohibited for some discs)
terminals or are not connected
input terminal
(Check input - CD, AUX etc. - selector)
and a DVD disc because of the original recording
methods
Reference page
p.11
p.10
p.54
p.9
p.44
p.44
p.14
p.8
p.40
p.44~48