Connection Example 3. Av Amp; Components - Pioneer DVD-V7200 Operating Instructions Manual

Connection Example 3
AV amp
Connect the player's audio output jacks to an amp's CD, LD, AUX or other audio input jacks. (Do not connect to PHONO jacks)
Connect the player's video output jack to the amp's video input jack
When connecting to a component bearing the Pioneer Î mark:
If you use a commercially available cord with a mini plug (no resistance) to connect this player's EXT.CONT jack to the
control output jack of another component bearing the Î mark, the player is controlled as if it were a component in a system
(system control).
¶
A player under system control, ignores commands sent through the remote control.
¶
Connect the amplifier using an audio cord, even if using only digital components when the system controls the unit
¶
Surround sound can be enjoyed with amplifiers that have a built-in Dolby Pro Logic decoder
¶
For further information, refer to the other device's operation manual
Connection Example 4
Digital recording components
Make digital output (Coaxial) connection
¶ Connect the DVD player's PCM/Ÿ output connector to the digital input connector on the device used for digital recording
When recording a Dolby digital compatible DVD, set
"Digital output" to the PCM setting as explained on
page 39. When the disc is recorded in Dolby Digital
(AC-3), noise is audiable if the setting is left at PCM/
DOLBY DIGITAL
48 Connecting the Player
<VRB1185>
INTERFACE CONNECTOR
R L
PCM/
AUDIO OUT
DIGITAL OUT
OFF ON
75 Ω
BLACK BURST
EXIT SYNC IN
AUDIO IN
AV amplifier
INTERFACE CONNECTOR
R
AUDIO OUT
OFF ON
75 Ω
BLACK BURST
EXIT SYNC IN
DIGITAL IN
Digital recorder
(MD, CD-R, DAT, etc.)
Note
DC 5V 40mA
AUDIO VIDEO
OUT
(MONO)
VHF ADAPTER S-VIDEO OUT
VIDEO IN
DC 5V 40mA
AUDIO VIDEO
L
(MONO) OUT
PCM/
VHF ADAPTER
DIGITAL OUT S-VIDEO OUT
Cables can be found at local audio/video dealers
By connecting to a regular AV
amp or stereo amp, you can
enjoy playback with improved
sound quality.
Finally, connect
to a wall
outlet
Digital recording components
such as an MD, CD-R or DAT
may be connected
Finally, connect
to a
wall outlet.