Main Charging; Photo Conductive Drum - Kyocera Mita Ecosys FS-1010 Service Manual

(1) Main charging

Photo conductive drum

The durable layer of organic photoconductor (OPC) is coated over the aluminum cylinder base.
The OPC tend to reduce its own electrical conductance when exposed to light. After a cyclic process
of charging, exposure, and development, the electrostatic image is constituted over the OPC layer.
Since the OPC is materialized by resin, it is susceptible to damage caused by sharp edges such as a
screwdriver, etc., resulting in a print quality problem. Also, finger prints can cause deterioration of
the OPC layer, therefore, the drum (in the process unit) must be handled with care. Substances like
water, alcohol, organic solvent, etc., should be strictly avoided.
As with all other OPC drums, the exposure to a strong light source for a prolonged period can cause
a print quality problem. The limit is approximately 500 lux for less than five minutes. If the drum
(process unit) remains removed form the printer, it should be stored in a cool, dark place.
Photo conductive layer
Aluminum base cylinder
Figure 4-1-3 Photo conductive drum
FS-1010
4-5