Specifications; Working Range (Line Of Sight); Audio Frequency Response; Input Impedance - Shure SVX4 User Manual

SPECIFICATIONS

Working Range (Line of Sight)
HI power mode: 75 m (250 ft)
LO power mode: 18 m (60 ft)
Note: Actual range depends on RF signal absorption,
reflection and interference.

Audio Frequency Response

50 Hz to 15 kHz
Note: Dependent on microphone type
Total Harmonic Distortion (Ref. ±48 kHz
deviation, 1 kHz tone)
<1%

Dynamic Range

90 dB A-weighted, typical
Operating Temperature Range
–10°C (14°F) to 50°C (122°F)
Note: Battery characteristics may limit this range.
Transmitter Audio Polarity
Positive pressure on microphone diaphragm produces positive
voltage on pin 2 (with respect to pin 3 of XLR output) and the tip
of the 6.35 mm (1/4-inch) output.
SVX1 Bodypack
Transmitter
Audio Input Level
MIC: -7 to -15 dBV
LINE: 9 to 1 dBV
Gain Adjustment Range
8 dB

Input Impedance

MIC setting: 16 kΩ
LINE setting: 120 kΩ
RF Output (dependent on applicable country
regulations)
10 mW maximum
Dimensions
108 mm X 64 mm X 19 mm (4.25in. X 2.50in. X 0.75in.)
Weight
90 g (without batteries)
Housing
Molded ABS
Power Requirements
2 "AA" size alkaline or rechargeable batteries
Battery Life
up to 10 hours (alkaline)
SVX2 Handheld
Transmitter
Audio Input Level
–20 dBV maximum
Input Impedance
22 kΩ
RF Output (dependent on applicable country
regulations)
HI power mode: 10 mW maximum
LO power mode: 1 mW maximum
Dimensions
254 mm X 51 mm diameter (10in. X 2 in.)
Weight
270 g (10.2 oz.)(without batteries)
Housing
Molded ABS
Power Requirements
2 "AA" size alkaline or rechargeable batteries
Battery Life
up to 10 hours (alkaline)
SVX4 Receiver
Dimensions
32 mm X 168 mm X 104.5 mm (1.26 in. x 6.625 in. x 4.2 in.)
Weight
245 g (11.5 oz.)
Housing
Molded ABS
Audio Output Level (Ref. ±48 kHz deviation
with 1 kHz tone)
XLR connector into 100 kΩ load: -16 dBV (MIC)
6.35 mm (1/4") connector into 100 kΩ load: -22 dBV (MIC)
Output Impedance
XLR connector: 600 Ω
6.35 mm (1/4") connector: 600 Ω
Sensitivity
–105 dBm for 12 dB SINAD, typical
Image Rejection
>50 dBm, typical
Power Requirements
12 to 18 V DC @ 130 mA, supplied by external power supply
10