Graco M73109 A Series Instructions-Parts List Manual page 7

NOTE: Refer to the turbine gun manual, 308–336, for
information on the operation and setup of the gun.
Connect the Fluid and Air Supply
1. Connect the hose to the gun.
2. Connect the gun air supply hose (A) between the
turbine air outlet (D) and the gun air inlet. DO
NOT use a wrench to tighten connections; hand–
tighten only. See Fig. 1.
3. If using a spray gun cup (B), connect the cup to
the gun fluid inlet.
4. For Series 800 only: If using an accessory remote
pressure pot (C), connect the fluid supply hose (G)
between the gun fluid inlet and the remote pres-
sure pot.
Connect the air hose (E) between the pressure pot
air inlet and the compressor air outlet (F).
G
Z
E
Y
2-1/2 Gallon Remote Pressure Pot
Part No. M70604 (see Accessories)
Fig. 1
Setup
Air Control Valve
(used to shut off air
without shutting off
turbine)
A
X
G G
Z
Z
C
2 Quart Remote Pressure Pot
Part No. M70962 (see Accessories)
NOTES:
The circled letters in Fig. 1 indicate hose line con-
nections.
Only the Series 800 turbine unit includes a com-
pressor for use with a remote pressure pot.
Connect to Electric Supply
1. Plug the sprayer power cord into a grounded
outlet.
2. If an extension cord is used, it must be 3-wire, 12
AWG and 100 ft or less in length.
B
B
E
Y
C
X
Air Control Valve
(used to shut off
air without shut-
ting off turbine)
A
X
Y
A D F
E
Series 800
Turbine shown
04958