Table of Contents
Advertisement
EQUIPMENT MISUSE HAZARD
Equipment misuse can cause the equipment to rupture or malfunction and result in serious injury.
INSTRUCTIONS
This equipment is for professional use only.
Read all instruction manuals, tags, and labels before operating the equipment.
Use the equipment only for its intended purpose. If you are not sure, call Graco Technical Assis-
tance at 1–800–543–0339.
Do not alter or modify this equipment.
Check equipment daily. Repair or replace worn or damaged parts immediately.
Do not exceed the maximum working pressure of the lowest rated system component. The Series
700 and 800 turbines have a working pressure of 5 psi (0.34 bar) and the Series 900 has a working
pressure of 6 psi (0.41 bar).
Use fluids and solvents which are compatible with the equipment wetted parts. Refer to the Speci-
fications on page 6 for this information.
Do not use hoses to pull equipment.
Route hoses away from traffic areas, sharp edges, moving parts, and hot surfaces. Do not expose
Graco hoses to temperatures above 82 C (180 F) or below –40 C (–40 F).
Wear hearing protection when operating this equipment.
Do not lift pressurized equipment.
Comply with all applicable local, state, and national fire, electrical, and safety regulations.
Do not point the gun at anyone or at any part of the body.
Do not put your hand or fingers over the gun fluid nozzle.
Do not stop or deflect leaks with your hand, body, glove or rag.
Do not "blow back" fluid; this is not an air spray system.
Follow the Pressure Relief Procedure on page 11 if the fluid nozzle clogs and before cleaning,
checking or servicing the equipment.
Tighten all fluid connections before operating the equipment.
Check the hoses, tubes, and couplings daily. Replace worn or damaged parts immediately.
WARNING
Advertisement
Table of Contents
