Graco M73109 A Series Instructions-Parts List Manual page 25

NOTE: See selection charts in the gun turbine manual,
308–336, to order fluid sets.
Lubricant 111–265
One 4 oz. (113 gram) tube sanitary (non-silicone)
lubricant for fluid seals and wear areas.
#4 Ford Viscosity Cup M70702
Used to measure viscosity of fluid.
1 Quart Cup Lid M70610
Fits on 1 qt under–cup for air tight storage of fluid.
1 Quart Cup M71667
1 quart under-cup.
1 Quart Cup Gaskets M70425
5 pack of polyethylene gaskets for use with 1 quart
under-cup.
1 Quart Under-Cup Assembly M71660
Complete 1 quart under-cup assembly.
Cup Check Valve M71007
To help prevent the cup from depressurizing after the
air is shut off.
Fluid Strainer M70464
Install on the end of the cup or pressure pot fluid tube
to strain the fluid and help eliminate surface blemishes
and plugged tips. 100 mesh screen.
Blow Gun M70703
For dusting and drying. With quick disconnect.
Contractor User Kit M70704
Used for fine finish materials and heavier bodied
materials (latex). Includes:
Part No. Description
M70562 1.0 mm Fluid Set
M70582 2.0 mm Fluid Set
M70425 1 Quart Under-cup Gaskets (5-pack)
M70464 Fluid Strainer
M70395 Upper Air Pressure Hose
– Parts Box with Compartments
Accessories
Automotive User Kit M70705
For use with automotive finishes. Includes:
Part No.
M70559
M70647
M70425
M70464
M70395
–
Trail Around Dolly M70700
Lightweight and mobile platform with wheels; for use
with Series 700, Series 800, and Series 900.
45 Degree Elbow M70593
Attaches between gun and turbine air hose; increases
maneuverability.
Y Fitting Kit M70611
Creates two air connections; allows for two–gun
operation.
Series 800 1/4 in. ID Compressor Air Hose (with
Female Quick Disconnect)
PVC, Maximum Working Pressure: 150 psi (10.3 bar)
Part No.
M70665
M71631
3/8 in. ID Paint Fluid Hose
LDPE, Maximum Working Pressure: 175 psi (12 bar)
Part No.
M71482
M71481
M71484
M71486
M71485
Material Hose Connector M70693
For use with 3/8 in. paint fluid hose.
3/4 in. ID Turbine Air Hose with Spring
PVC, Maximum Working Pressure: 100 psi (6.9 bar)
Part No.
M71452
M71453
M71454
M71455
3/4 in. ID Turbine Air Hose Extension without
Spring
PVC, Maximum Working Pressure: 100 psi (6.9 bar)
Part No.
M71460
M71461
M71462
M71463
M71464
Description
1.0/0.05 mm Fluid Set
1.2/0.7 mm Fluid Set
1 Quart Under-cup Gaskets (5-pack)
Fluid Strainer
Upper Air Pressure Hose
Parts Box with Compartments
Length
20 ft (Extension)
25 ft (Replacement)
Length
15 ft
25 ft
30 ft
40 ft
50 ft
Length
25 ft
30 ft
40 ft
50 ft
Length
10 ft
15 ft
20 ft
25 ft
30 ft