Adjusting The Main Dial Torque; Restarting Power After A Voltage Fluctuation - Yaesu FTDX9000MP Operation Manual

5. Adjusting the Main Dial Torque

The torque (drag) of the Main Tuning Dial may be adjusted according to your preferences. Simply hold down the rear skirt
of the knob, and while holding it in place rotate the Main Dial itself to the right to reduce the drag, or to the left to increase
the drag.

6. Restarting Power after a Voltage Fluctuation

If your AC mains power should suffer a significant fluctuation or interruption, we recommend that
you go through a complete power-up cycle, in order to ensure that all circuits are properly initialized.
To do this, be sure the front panel Power switch is turned off, then set the FPS-9000H's Power switch
to the "O" position. Now unplug the AC cable from the rear panel of the FPS-9000H, and wait ten
seconds. Plug the AC cable back in, set the FPS-9000H's Power switch to "O," and now press and
hold in the front-panel Power switch for two seconds to turn the transceiver on. After about 50 sec-
onds, all circuits wil be initialized, and normal operation may resume.
Page 6
B B B B B Y Y Y Y Y B B B B B
EFORE EFORE EFORE OU OU OU OU OU EGIN EGIN EGIN
EFORE EFORE EGIN EGIN
T T
IGHTEN OOSEN
. . . . . . . . . . . . . . .
H S
OLD THE KIRT
FT 9000MP O
DX PERATION
M
ANUAL