Yaesu FTDX9000MP Operation Manual page 153

GENERAL G
043. MIC SCAN
Function: Enables/disables scanning access via the
microphone's [ UP ] / [ DWN ] keys (only available at the
rear panel's MIC Jack).
Available Values: ENABLE/DISABLE
Default Setting: ENABLE
044. MIC SCAN RESUME
Function: Selects the Scan Resume mode.
Available Values: PAUSE/TIME
Default Setting: TIME
PAUSE: The scanner will hold until the signal disap-
pears, then will resume after one second.
TIME: The scanner will hold for five seconds, then
resume whether or not the other station is
still transmitting.
045. AF/RF DIAL SWAP
Function: Reverses the functions of the [ AF GAIN ]
(VFO-B) and [ RF GAIN ] (VFO-A) knobs.
Available Values: NORMAL/SWAP
Default Setting: NORMAL
When this menu is set to "SWAP," you may adjust the
Sub (VFO-B) receiver audio using the large [ RF GAIN ]
(VFO-A) knob and adjust the Main (VFO-A) receiver
RF gain using the small [ AF GAIN ] (VFO-B) knob.
This puts both "Volume" controls on the same shaft.
FT 9000MP O
DX PERATION
ROUP
M
ANUAL
MODE-AM G
046. AM MIC GAIN
Function: Sets the microphone gain for the AM mode.
Available Values: MCVR/0 ~ 255 (FIX)
Default Setting: 160
When this menu is set to "MCVR," you may adjust
the microphone gain using the front panel's MIC knob.
047. AM MIC SELECT
Function: Selects the microphone to be used on the
AM mode.
Available Values: FRONT/REAR/DATA/PC
Default Setting: FRONT
FRONT: Selects the microphone connected to the
front panel's MIC jack while using the AM
mode.
REAR: Selects the microphone connected to the
rear panel's MIC jack while using the AM
mode.
DATA: Selects the microphone connected to pin 1
of the PACKET Jack while using the AM
mode.
PC: Selects the microphone connected to the
rear panel's AUDIO IN 3.5-mm jack while
using the AM mode.
M M M M M M M M M M
ENU ENU ENU ODE ODE ODE
ENU ENU ODE ODE
ROUP
Page 151