Yaesu FTDX9000MP Operation Manual page 121

Text Message Programming
1. Press the [ CW ] Mode key to set the operating mode
to CW.
2. Be sure that Break-in is Off by pressing the [ BK-IN/
SPOT ] key, if necessary.
3. Press the FH-2's [ MEM ] key.
4. Press the FH-2's [ 1 ] ~ [ 5 ] key to select the desired
Message Memory Register into which you wish to pro-
gram the text.
5. Use the FH-2's [ ] amd [
position and use the [ ] and [ ] keys to choose the
letter/number to be programmed in each slot of the
memory. In the case of the second example above, the
"}" character designates the slot where the Contest
Number will appear.
A A A A A
:
D D D D D VICE VICE VICE VICE
VICE
You may also use the [ MAIN Tuning Dial ] knob and
the [ CLAR/VFO-B ] knobs to program the message
characters.
6. Press the FH-2's [ MEM ] key again once all charac-
ters have been programmed.
FT 9000MP O
DX PERATION
C M
ONTEST
LOCK
ON OFF
LOCK
ON OFF
] keys to set the cursor
LOCK
ON OFF
M
ANUAL
CW C CW C CW C
CW C CW C
ONVENIENCE ONVENIENCE ONVENIENCE
ONVENIENCE ONVENIENCE
K
EMORY EYER
Checking the CW Memory Contents
1. Be sure that Break-in is still turned Off.
2. Press the FH-2's [ 1 ] ~ [ 5 ] key to check your work.
You will hear the results in the sidetone, but no RF
energy will be transmitted.
On-The-Air CW Message Playback
1. Press the [ BK-IN/SPOT ] key to enable transmission.
Either Full- or Semi-break-in will be engaged, depend-
ing on the setting of Menu item "MODE-CW 054
CW BK-IN".
2. Press the FH-2's [ 1 ] ~ [ 5 ] key to transmit the pro-
grammed message.
N N N N N
:
O O O O O TE TE TE TE TE
If you subsequently decide to use the "MESSAGE" tech-
nique for memory storage, please note that the contents of
a message stored using text input will not be transferred
over when you select "MESSAGE" on a particular memory
register.
Correcting/Editing
Previously-Stored Characters
Use the [ Main Tuning Dial ] knob to select the
letter/number to be corrected, then rotate the
[ CLAR/VFO-B ] knob to choose the revised let-
ter/number top be utilized in this slot.
Deleting Previously-stored Characters
Use the [ MAIN Tuning Dial ] knob to select the
last correct letter in the message. Now rotate the
[ CLAR/VFO-B ] knob to select the " } " character;
everything after the " } " character will be deleted.
F F F F F
EA EA EA EA EA TURES TURES TURES TURES
TURES
LOCK
ON OFF
LOCK
ON OFF
Page 119