Basic Operation: Receiving On Amateur Bands - Yaesu FTDX9000MP Operation Manual

Hide thumbs Also See for FTDX9000MP:
Table of Contents

Advertisement

Before turning on main power, please verify the following items once more.
Have you made all ground connections securely? See page 14 for details.
Do you have your antenna(s) connected to the rear-panel Antenna jack(s)? See page 14 for details.
Is your microphone (and/or key or paddle) connected? See page 15 and 16 for details.
If using a linear amplifier, have all interconnections been successfully completed? See page 17 and 18 for details.
Please rotate both [ AF GAIN ] controls to their fully counter-clockwise positions, to avoid a loud blast of audio when
the transceiver turns on. See page 29 and 32 for details.
Rotate the [ RF PWR ] control fully counter-clockwise, to set minimum power at first. See page 29 for details.
When first using the transceiver on a voice mode, you must tell it which microphone jack you wish to use (by default, the
front panel's "Cannon" (XLR) connector is connected, and the rear panel's 8-pin round mic jack is not connected. You
may use Menu "MODE-SSB 076 SSB MIC SELECT" to set the desired microphone jack for the LSB and USB
modes. Similarly, use Menu "MODE-AM 047 AM MIC SELECT" for the AM mode, and Menu "MODE-FM 066
FM MIC SELECT" for the FM mode.
N N N N N
:
O O O O O TE
TE
TE
TE
TE
If the wrong microphone jack is selected, voice transmission will not be possible.
Once AC power is applied, please refer to the "Data Manegement Operation Manual" and perform the setup for the
Local Time. If this setup procedure is not performed, the World Clock and Logbook functions will not operate correctly.
If your AC mains power should suffer a significant fluctuation or interruption, we recommend that you go through a
complete power-up cycle, in order to ensure that all circuits are properly initialized. To do this, be sure the front panel
Power switch is turned off, then set the FPS-9000H's Power switch to the "O" position. Now unplug the AC cable from
the AC line, and wait ten seconds. The start-up procedure is described on the next page.
FT
9000MP O
DX
PERATION
B B B B B
O O O O O
ASIC
ASIC
PERA
PERA
TION
TION
ASIC
ASIC
ASIC
PERA TION
PERA
PERA
TION
TION
M
ANUAL
: : : : : R R R R R
A A A A A
ECEIVING ON ON ON ON ON
ECEIVING
ECEIVING
ECEIVING
ECEIVING
B B B B B
MA MA MA MA MA TEUR
TEUR
TEUR
ANDS
ANDS
TEUR
TEUR
ANDS
ANDS
ANDS
Page 43

Advertisement

Table of Contents
loading

Table of Contents