Assembly Instructions - Flymo Micro Lite User Instructions

CABLES
IMPORTANT
• Use only 1.00mm 2
length maximum.
Maximum rating :
1.00mm 2 size cable, 10 amps 250 volts AC.
• THE MICRO LITE IS SUPPLIED WITH CABLE
WIRED DIRECTLY INTO THE PRODUCT.
1. Flymo Mains Cables and Extension Cables are
available from your local Approved Service Cen-
tre.
2. Do not wire an extension cable directly to your
product yourself. Please contact your local Ap-
proved Service Centre for further information on
the connectors and kits available.
3. Only use extension cables specifically designed
for outdoor use.
CONNECTORS
IMPORTANT
• Flymo connectors are suitable for use with 2 core
cable only. Under no circumstances should these
connectors be used for earthed products.
• All Flymo connectors and cables are of splash-
proof construction. They are not waterproof and
must not be left outside permanently nor should
they be submerged or immersed in water. Do
not let cable lay or trail through pools of water or
splashed with water from hose pipes.
MAINS PLUG REPLACEMENT
IMPORTANT
• If the plug supplied is cut off it should be destroyed.
There is an electric shock hazard if a cut off plug is
inserted into a 13 amp socket.
1. No earth required. Flymo products are double in-
sulated to EN60335 and under no circum-
stances should an earth be connected to any
part of the product.
A
2
B
1
2
size cable up to 40 metres

Assembly Instructions

1
1
2
lock-off
button
2. Ensure the mains voltage suits your product
3. IMPORTANT!
BLACK
BLUE
The wires in the mains lead are coloured in ac-
cordance with the following code:
BLUE
BROWN
The wire which is coloured BLUE must be con-
nected to the Terminal which is marked with the
letter 'N' or coloured BLACK.
The wire which is coloured BROWN must be
connected to the Terminal which is marked with
the letter 'L' or coloured RED.
4. It is important that the outer sheath is clamped
correctly into the 3-pin plug.
5. If in doubt consult your local Service Repairer or
qualified electrician before the machine is used.
6. A 13 Amp fuse must be fitted to the Mains Plug.
7. The normal plug fuse and household fuse only
protect the electrical equipment and are not a
safeguard against electrocution.
If your product is hard wired i.e. non-detachable
mains electric cable, a conversion kit and exten-
sion cable is available from all Approved Service
Centres which can be found in your local Yellow
Pages.
Lower Handle to Hood Assembly (A)
• Ensure the motor cover is fitted correctly, as il-
lustrated
• Tilt motor cover into forward position before
assembly
1. Insert lower handles through the 2 holes in the
motor cover and push down.
2. Secure lower handles to hood by firmly pushing
fixing pins through holes in motor cover, handle
and hood.
Fitting Upper Handles to Lower Handles (B)
1. Ensure the upper handle is located correctly with
the lock-off button on the switchbox uppermost
2. Ensure the upper handle and the lower handle
are aligned correctly.
3. Insert the nut into the handle knob (B1).
4. Fit the bolts, washers and handle knobs (B2).
5. Fit the cable to the handles with the clips pro-
vided (B3). Make sure the cable is not trapped
between the handles.
3
E
L
BROWN
F
U
S
E
OR
N
- NEUTRAL
- LIVE
RED
OR