Adjusting The Cutting Height; Assembly Instructions - Flymo PC 330 Important Information Manual

3
A
B
grassbox
C
D
nut (if
applicable)
handle
knob
washer
E
HIGHEST
G
HEIGHT OF CUT
Heights of cut:- 1 & 2 - low, 3 & 4 - medium, 5 & 6 - high

Assembly Instructions

lid
lower
handle
fixing
pins
bolt

Adjusting the Cutting Height

F FRONT
POWER COMPACT
330
H LOWEST
HEIGHT OF CUT
Assembly of Lower Handles to Deck
1. Insert lower handle into holes in the deck and
push into place (A).
2. Release the grassbox catch and lift the
grassbox lid (B).
3. Rest the grassbox lid against the lower han-
dle and remove the grassbox.
4. Ensure that the holes in the lower handle are
correctly located behind the holes in the
deck.
5. Secure the lower handles to the inside of the
deck with the lower handle fixing pins (C).
6. Ensure the fixing pins are securely located.
7. Should a problem occur when securing lower
handle to deck, carefully lever fixing pins out
of location and repeat steps 4 to 6 above.
8. Replace the grassbox and close the grass-
box lid.
Assembly of Upper Handles to Lower
Handles.
1. Ensure the upper handle is located correctly
with the lock-off button on the switchbox
uppermost
2. Ensure the upper handle and the lower han-
dle are aligned correctly. (D)
3. Insert the nut into the handle knob (if applica-
ble) (D).
4. Fit the bolts, washers and handle knobs.(D)
5. Fit the cable to the handles with the clips
provided. Make sure the cable is not trapped
between the upper and lower handles.
Cutting Height Adjustment - Power Compact 330
Rear Height Adjustment
1. Select one of the 5 locations and note it as
the other lever will need to be adjusted to the
same position. (E)
2. Lift the lever out of location and rotate to the
desired position. (E)
3. The roller moves with the wheels when the
cutting height is adjusted. (G & H)
Front Height Adjustment
1. Using the same height adjustment position
repeat the procedure for the other lever (F).
Cutting Height Adjustment - Power Compact 400
1. Lift the lever out of location and rotate to the
desired position. (E)
2. The roller moves with the wheels when the
cutting height is adjusted. (G & H).