Table of Contents
Advertisement
accessed through the management-module VLAN. Review the following figure
only as an example of establishing a TCP/IP session through the management
module or through the external interface.
Client B
Telnet
10.10.1.2
Client A manages the Gigabit Ethernet switch module through the default
management-module configuration interface. The management module is
always enabled and always a member of VLAN 1. VLAN 1 can never be
disabled. You can always manage the Gigabit Ethernet switch module over this
interface, provided that the IP addresses of the client, the management module,
and the Gigabit Ethernet switch module are on the same subnet, as shown in
the following table.
Network entity
Client A
Management module
Gigabit Ethernet switch module
Default VLAN
VLAN 2
17
18
10.10.1.1
19
20
Chapter 3. Configuring the Gigabit Ethernet switch module
Client A
HTTP
192.168.70.1
MGT1
15
192.168.70.127
GbE
IP address
192.168.70.1
192.168.70.125
192.168.70.127
eth0
192.168.70.125
MM
eth1
192.168.70.126
eth1
Mgmt VLAN
VLAN 1
21
Advertisement
Table of Contents
