Initial Vlan Configuration - Cisco Ethernet switch Installation Manual

v Verify that the Cisco IOS software is installed on the Gigabit Ethernet switch
module
v Configure at least one IP interface on the Gigabit Ethernet switch module
v Enable the frames and the JavaScript
v The following hardware and software are required for the Web interface:
– A frame-capable Web-browser program, such as Internet Explorer (version
6.0 or later) or Netscape Navigator (version 4.7 or later)
– A computer or workstation with network access to the Gigabit Ethernet
switch module
To start the Web interface, complete the following steps:
1. Start a Web browser. The Web-browser window opens.
2. In the URL field, enter the IP address of the Gigabit Ethernet switch
module, in the following format
http://xxx.xxx.xxx.xxx. The login window opens.
3. Enter your user ID and password. If you do not have an assigned user ID
and initial password, type the default user ID (USERID) in the User Name
field and the default password (PASSW0RD, where the 0 is a zero) in the
Password field and click OK.
Note: The passwords used to access the Gigabit Ethernet switch module are
case-sensitive. To increase system security, change the password after
you log on for the first time.

Initial VLAN configuration

The IOS software on the Gigabit Ethernet switch module contains default
configuration files that are installed during in the software installation. These
initial configuration settings are not located in a separate configuration file, but
they are components of the IOS software. When you restore the management
module to factory defaults, the user defined configuration file is deleted and
the original IOS configuration is reloaded. This is different from other
stand-alone Cisco Ethernet switches.
28
Cisco Systems Intelligent Gigabit Ethernet Switch Module: Installation Guide
™
program in your Web browser