Main Control Board Replacement; Flame Led Light And Media Light Assembly Replacement - Dimplex PF2325 Service Manual

MAIN CONTROL BOARD REPLACEMENT

Tools Required: Phillips Head Screwdriver
Flat Head Screwdriver
Needle Nose Pliers
CAUTION: If unit was operating prior to servicing allow
at least 10 minutes for heating elements and top panel to
cool off to avoid accidental burning of skin.
WARNING: Disconnect power before attempting any
maintenance to reduce the risk of electric shock or damage
to persons.
1. Unplug the unit from power outlet.
2. Remove the firebox from the front of the mantel and
remove front glass assembly (glass lifts off).
CAUTION: Even though the glass is safety glass it
may break if bumped, struck of dropped. Care must be
taken when handling the glass.
3. Remove the loose media from the unit (if applicable).
Figure 3
Top Panel
Figure 4
gWave Assembly
Heater Assembly
Flicker Motor
Flame LED Light Assembly
Back Panel
Top LED Light
Main Control Board
Floating Display
Assembly
4. Remove the 14 screws around the back panel of the
firebox and the 3 along the middle of the panel (Figure
3).
5. Locate the main control board and transfer the wir-
ing connections from the old board to the new board.
(Figure 4)
!
NOTE: A flat head screwdriver can be used to gently
pry between the end of the connector and the main control
board to release the wires.
6. Release the main control board from the unit by using
needle nose pliers to depress the tab on the mounting
standoffs and gently lift the driver board off.
7. Properly orient and insert the new main control board.
8. Reassemble in the reverse order as above.
FLAME LED LIGHT AND MEDIA LIGHT
ASSEMBLY REPLACEMENT
Tools Required: Phillips Head Screwdriver
Small Adjustable Wrench
CAUTION: If unit was operating prior to servicing allow
at least 10 minutes for heating elements and top panel to
cool off to avoid accidental burning of skin.
WARNING: Disconnect power before attempting any
maintenance to reduce the risk of electric shock or damage
to persons.
1. Unplug the unit from power outlet.
2. Remove the firebox from the front of the mantel and
remove front glass assembly (glass lifts off).
CAUTION: Even though the glass is safety glass it
may break if bumped, struck of dropped. Care must be
taken when handling the glass.
3. Remove the loose media from the unit (if applicable).
4. Remove the 14 screws around the back panel of the
firebox and the 3 along the middle of the panel (Figure
3).
5. Locate the flame LED light assembly, at the bottom of
the unit. (Figure 4)
6. Locate and remove the two screws on either end secur-
ing the bracket, that the light assembly and the flicker
rod are attached to, and remove assembly (Figure 5).
7. Using the small adjustable wrench remove the 3 nuts to
remove the LED light assembly.
Figure 5
Mounting Screws
Securing Nuts
Flame LED Light
Media LED Light
9