Table of Contents
Advertisement
board.
5. Ensure that all cords are replaced in the same manner
as prior to the service.
6. Reassemble in the reverse order as above.
FLOATING DISPLAY ASSEMBLY
REPLACEMENT
WARNING: Disconnect power before attempting any
maintenance or cleaning to reduce the risk of electric
shock or damage to persons.
CAUTION: If unit was operating prior to servicing allow
at least 10 minutes for lights and heating elements to cool
off to avoid accidental burning of skin.
Tools required: Phillips head screwdriver
CAUTION: Follow "Preparation for Service" instructions
before proceeding.
1. Locate the floating display assembly. (Figure 12)
2. Remove the 2 screws securing the board to the mount-
ing bracket.
3. Install the new board onto the unit.
4. Trace the connector from the assembly location to the
electronics junction board, remove the old connection
and replace with the new connector.
5. Ensure that all cords are replaced in the same manner
as prior to the service.
6. Reassemble in the reverse order as above.
LED DRIVER BOARD REPLACEMENT
WARNING: Disconnect power before attempting any
maintenance or cleaning to reduce the risk of electric
shock or damage to persons.
CAUTION: If unit was operating prior to servicing allow
at least 10 minutes for lights and heating elements to cool
off to avoid accidental burning of skin.
Tools required: Phillips head screwdriver
Figure 12
Main Control Board
Electronics Junction
Board
Relay Board
LED Driver Board
Thermistor
Floating Display Assembly
CAUTION: Follow "Preparation for Service" instructions
before proceeding.
1. In the upper right hand corner of the unit, above the
floating display board, locate the control board cover
panel and remove the 2 securing screws. (Figure 11)
1. Locate the LED driver board. (Figure 12)
2. Remove the board by pinching the plastic mounting
tabs with needle nose pliers. Pull the old board off.
3. Install the new board onto the unit.
4. Transfer the connections from the old board to the new
board.
5. Ensure that all cords are replaced in the same manner
as prior to the service.
6. Reassemble in the reverse order as above.
MAIN CONTROL BOARD
REPLACEMENT
WARNING: Disconnect power before attempting any
maintenance or cleaning to reduce the risk of electric
shock or damage to persons.
CAUTION: If unit was operating prior to servicing allow
at least 10 minutes for lights and heating elements to cool
off to avoid accidental burning of skin.
Tools required: Phillips head screwdriver
CAUTION: Follow "Preparation for Service" instructions
before proceeding.
1. In the upper right hand corner of the unit, above the
floating display board, locate the control board cover
panel and remove the 2 securing screws. (Figure 11)
1. Locate the main control board. (Figure 12)
2. Remove the board by pinching the plastic mounting
tabs with needle nose pliers. Pull the old board off.
3. Install the new board onto the unit.
4. Transfer the connections from the old board to the new
board.
5. Ensure that all cords are replaced in the same manner
as prior to the service.
6. Reassemble in the reverse order as above.
RELAY BOARD REPLACEMENT
WARNING: Disconnect power before attempting any
maintenance or cleaning to reduce the risk of electric
shock or damage to persons.
CAUTION: If unit was operating prior to servicing allow
at least 10 minutes for lights and heating elements to cool
off to avoid accidental burning of skin.
Tools required: Phillips head screwdriver
CAUTION: Follow "Preparation for Service" instructions
before proceeding.
1. In the upper right hand corner of the unit, above the
floating display board, locate the control board cover
panel and remove the 2 securing screws. (Figure 11)
1. Locate the relay board. (Figure 12)
11
Hide quick links:
Advertisement
Table of Contents
