Checking The Communication Using The Ping Command - Epson DS-560 Network Manual

DS-560 Network Guide
Windows 7/Windows Vista/Windows XP:
Start > All Programs or Programs > EPSON > EPSON Scan > EPSON Scan Settings
Mac OS X:
Select Applications > EPSON Software > EPSON Scan Settings.
B
Click Test.
Checking the Wi-Fi module firmware version
A
Start EpsonNet Config.
Windows 8.1/Windows 8:
Start screen > Apps > EpsonNet > EpsonNet Config
Windows 7/Windows Vista/Windows XP:
Start > All Programs or Programs > EpsonNet > EpsonNet Config VX* > EpsonNet Config
Mac OS X:
Select Applications > Epson Software > EpsonNet > EpsonNet Config VX* > EpsonNet Config.
* Where "X" is the software version.
B
Select your scanner, and then click Configuration.
C
Select Network Interface - Information - Basic.
D
Click Software Information....

Checking the communication using the Ping command

You can use this feature to confirm whether communication is established between the computer and the product.
This method is only available if you have acquired the product's IP address in advance, such as in the following
situations.
❏ You have set a static IP address for the product and have taken a note of it.
❏ You took a note of the product's IP address when you setup the network, and it has not been changed by settings on
the access point or the product.
For more details about operating the computer, refer to
Ping command
In the TCP/IP network environment, confirm the IP addresses set on the computer and product, then check whether
communication is established between the computer and product.
Troubleshooting
"Ping command" on page
24
24.