Chapter 5 Tips For Administrator; Network Setup Menu; Setting An Ip Address Using The Arp/Ping Command - Epson 11880 - Stylus Pro Color Inkjet Printer Network Manual

Chapter 5
Tips for Administrator

Network Setup Menu

These items are used to make network settings on the printer's control panel.
Item
NETWORK SETUP
IP ADDRESS SETTING*
IP*
SM*
DG or GW*
Bonjour*
INIT NETWORK
SETTING*
* Available only when Enable is selected for NETWORK SETUP.

Setting an IP Address Using the arp/ping Command

Follow the steps below to set the IP address using the arp/ping command.
Note:
❏ Make sure that the Set using PING function is enabled on the TCP/IP menu in EpsonNet
Config. If this function is disabled, you cannot set the IP address using the arp/ping command.
❏ Make sure the network interface and the computer are in the same segment.
Before you start, you need the following information:
❏ A valid IP address for the network interface. Ask your network administrator for an
IP address which does not cause conflicts with any other device on the network. If
you are the network administrator, choose an address within your subnet which does
not conflict with any other device.
❏ The MAC (Ethernet hardware) address of the network interface. You can find out the
MAC address on a status sheet.
Settings (default in bold)
Disable, Enable
Auto, Panel
0.0.0.0 to 255.255.255.255
0.0.0.0 to 255.255.255.255
0.0.0.0 to 255.255.255.255
On, Off
EXECUTE
Tips for Administrator
41