Scanning Problems; Connecting To Wi-Fi - Epson DS-560 Network Manual

DS-560 Network Guide
For Windows 7: Click Start > Control Panel > Network and Internet > Network and Sharing Center > View
network status and tasks > Change adapter settings
For Windows Vista: Click Start > Control Panel > Network and Internet > Network and Sharing Center >
View network status and tasks > Manage network connections
For Windows XP: Start > Control Panel > Network and Internet Connections > Network Connections
B
Right-click Wireless Network Connection (DIRECT-xxxxxxxx), and then select Properties.
C
Select Internet Protocol Version 4 (TCP/IPv4), and then click Properties.
D
Click Advanced.
E
Clear Automatic metric, enter "100" in Internet metric, and then click OK.
Note:
If you still cannot connect to the Internet, perform the same operations from step 3 for Internet Protocol Version 6
(TCP/IPv6).

Scanning Problems

Connecting to Wi-Fi

Cannot start, set or scan with EPSON Scan
❏ Are you using the product's button?
When using a wireless connection, launch Epson Scan on your computer before scanning from the product
button.
❏ Was the connection test successful?
If it fails, verify that there are no problems with the network.
❏ Is the message " Network product is not available: currently being used by user." displayed?
There may be a communication error between the product and your computer. Turn off the product, and then
turn it back on.
❏ Are you using an IPv6 network?
Epson Scan does not support networks that use IPv6 only. Use Epson Scan on a network that uses IPv4.
❏ Is the IP address set correctly on the computer?
For details on network settings such as the IP address, see
❏ Was the communication disconnected?
If the communication was disconnected during EPSON Scan startup, exit EPSON Scan, and restart after a while. If
EPSON Scan cannot restart, turn the product off and back on, then retry.
Check the Timeout Setting in EPSON Scan Settings. For details, see the EPSON Scan Help.
Troubleshooting
"Setup Problems" on page
27
25.