HP ENVY x360 Convertible PC Maintenance And Service Manual page 62

4. Remove two Phillips PM2.5×5.5 screws from each hinge (1) and the smaller Phillips PM2.5×3.6 screw
from the right hinge (2) that secures the display assembly to the computer.
CAUTION:
assembly can result in damage to the display assembly and other computer components.
5. Remove the display assembly from the computer (3).
If it is necessary to replace any of the display assembly subcomponents:
1. To remove the display panel and bezel from the display enclosure:
NOTE:
a. Remove the two screw covers (1).
b. Remove the two Phillips PM2.5×4.0 screws (2) that secure the enclosure to the display panel.
c. Pry to separate the enclosure from the display (3).
2. The webcam module is mounted on the inside of the bezel. To remove the webcam module:
NOTE:
a. Position the display bezel/display panel assembly upside-down.
b. Disconnect the cable (1) from the module.
54 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
Support the display assembly when removing the screws. Failure to support the display
The display enclosure is available using spare part number 774591-001.
The webcam is available using spare part number 768040-001.