Remote Control - Hunter ceiling fan Owner's Manual

Remote Control

ON
Battery
Door
Phillips
Head
Screw
To access the battery compartment, remove
the small Phillips head screw that secures the
battery door to the transmitter assembly. The
battery should be installed with the positive
(+) side up. Replace with a CR2032 battery
when necessary.
M0065-01 • 04/23/13 • © Hunter Fan Company
fan, wait 1 minute then try again. If using the
16
www.HunterFan.com
Fan Off
High
Note: The remote must be paired before
the fan will operate.
Within 3 minutes of restoring power to
the fan, press both the Fan Off button and
the High button for at least 4 seconds. Your
fan will turn on low to indicate successful
syncing. If it does not, turn off power to your
transmitter with multiple fans, repeat this
process for each fan.
1.888.830.1326