Transmitting Dsc Calls - Icom IC-M506 Instruction Manual

Transmitting DSC calls

■
To ensure correct operation of the DSC function, make
sure you correctly set the CH70 SQL Level. (p. 71)
D Transmitting an individual call
The Individual call function allows you to transmit a DSC sig-
nal to only a specific station.
Enter "INDIVIDUAL CALL" in the DSC CALLS menu.
q
➪ ➪
MENU DSC
(Push [MENU]) (Select icon)
Select the desired pre-programmed individual address, or
w
"Manual Input," using dial or [Y]/[Z], then push [ENT].
• The ID code for the Individual call can be set first. (p. 19)
• When "Manual Input" is selected, set a desired 9 digit MMSI ID
code for the individual you wish to call.
• Push [EXIT] to return to the normal operating mode.
• Push [BACK] to return to the previous screen.
Individual Call
(Rotate dial, then push [ENT].)
About Manual Inputting:
Enter a desired individual ID in the following way:
• Select a desired number using [Y]/[Z]/[Ω]/[≈].
• Push [ENT] or dial to set it.
• To move the cursor, rotate dial or select either arrow, "←" or "→,"
then push [ENT] or dial.
• The first digit is specified as '0' for a Group ID. If a 9 digit Group ID
is entered, an error beep sounds when pushing [ENT] or dial.
• The first two digits are '0' for any coast station ID.
NOTE: When a coast station is selected in step w, the
voice channel is automatically specified by the coast sta-
tion. Therefore, skip step e and go directly to step r.
7
DSC OPERATION
+ Continued on the next page.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
28