Table of Contents
Advertisement
Operation of remote control unit
16
Loading batteries
1 Remove the cover.
Operation
Plug the power cord into the mains power outlet and press
the on/standby (
unit to turn power ON. After the power has been turned
ON, press the desired key.
To turn power off, press the on/standby (
key again. The system enters the standby mode in which
only the time display is lit.
÷ When pressing more than one remote control keys successively,
press the keys securely by leaving an interval of 1 second or more
between keys.
1. The provided batteries are intended for use in operation checking, and their service life may be short.
2. When the remote controllable distance becomes short, replace both of the batteries with new ones.
Notes
Notes
3. If direct sunlight or the light of a high- frequency fluorescent lamp (inverter type, etc.) is incident to the remote sensor, malfunction may occur.
In such a case, change the installation position to avoid malfunction.
CHANNEL SPACE setting
(Except for the U.S.A., Canada, U.K., Europe, Russia and Australia)
The space between radio channels has been set to the one that pre-
vails in the area to which the system is shipped. However, if the
current channel space setting does not match the setting in the area
where the system is to be used, for instance when you move from
area 1 or area 2 shown in the following table or vice versa, proper
reception of AM/FM (MW/FM) broadcasts cannot be expected. In
this case, change the channel space setting in accordance with your
area by referring to the following table.
Area
U.S.A., Canada and South
1
American countries
2
Other countries
2 Insert batteries.
÷ Insert two R6 ("AA"-size) batteries following
the polarity indications.
POWER) key of the remote control
POWER)
CHANNEL
SPACE freq.
FM : 100 kHz
AM : 10 kHz
FM : 50 kHz
AM :
9 kHz
3 Close the cover.
Remote sensor
6m
Operating range
(approx.)
1 Turn power off.
2 Select the channel space.
Each press switches the space frequency alternately.
1 "FM100/AM10 kHz" ....... STEP,
2 "FM 50 /AM 9 kHz" ....... STEP,
÷ The "AM" display is variable depending on the model (country or
area), and "MW" may be displayed in some areas.
F
M
1
0
F
M
5
0 / A M
3 Establish the selection.
XD-951/A900/A700 (En)
30˚
30˚
ON/STANDBY
0 / A M 1 0
9
ENTER
Hide quick links:
Advertisement
Table of Contents
