Let's Record; Recording (Deck B Only) - Kenwood XD-951 Instruction Manual

Let's record

28
Recording
(Deck B only)
When the equalizer or SRS 3D is applied to the sound, the sound with the applied effect can be recorded .
When Dolby Pro Logic, Dolby 3 Stereo or DSP mode is selected, cancel it by pressing the STEREO key of the remote control
unit.
0 1 1
PUSH
OPEN
2 7
REV.MODE
DOLBY NR
1. Load a tape in deck B.
A
1 Open the door of deck B.
2 Insert a tape.
3 Close the door.
2. Select the tape transport direction.
To reverse the transport direction
3
1 Press the play key corresponding to
the desired direction.
2 Stop playback (by pressing the &
key).
2 2
÷ When recording is started, the tape is trans-
ported in the direction selected in this step.
÷ Wind the tape to the position where recording
is to be started.
3. Set the recording condition.
1 Select the reverse mode.
2 Select the DOLBY NR mode.
3 3
Note that this cassette deck cannot record onto Metal tapes.
Note
Note
4 4
2 2
3 3
XD-951/A900/A700 (En)
1 1
5 5
÷ Differentiation between normal (TYPE
high (TYPE ) tape is set automatically.
÷ Remove tape slack before loading.
(Except for some areas)
÷ When the microphone is not used, set the MIC
VOL. control knob fully counterclockwise to
the minimum position.
Check the tape transport direction
indicator.
T A P E B 0 0 0 0
NR
Transport direction
i
) and