Operation Of Remote Control Unit - Kenwood XD Series Instruction Manual

Operation of remote control unit

Loading batteries
1 Remove the cover.
Operation
Plug the pow er cord of the amplifier unit (A-H5) into a
pow er outlet and press the ON/ STANDBY (
the remote control unit to turn pow er ON. When the pow er
is turned ON, press the desired operation keys.
To turn pow er off, press the
The system enters the standby mode in w hich only the
time display is lit.
÷ When pressing more than one remote control keys successively,
press the keys securely by leaving an interval of 1 second or more
betw een keys.
1. The provided batteries are intended for use in operation checking, and their service life may be short.
2. When the remote controllable distance becomes short, replace both of the batteries w ith new ones.
Notes
Notes
3. If direct sunlight or the light of a high- frequency fluorescent lamp (inverter type, etc.) is incident to the remote sensor, malfunction may occur.
In such a case, change the installation position to avoid malfunction.
Downloaded from: http://www.usersmanualguide.com/
2 Insert batteries.
÷ Insert tw o R6 (" AA" -size) batteries
follow ing the polarity indications.
) key of
(on/ standby) key again.
3 Close the cover.
30° 30°
M odel: RC-H7R
Infrared ray system
XD SERIES (En/ E2 )
Remote sensor
6 m
Operating range (approx.)
19