Installing SFP Modules
To remove a bale clasp SFP module from a port, perform the following steps:
Open the bale clasp on the SFP module with your index finger in a downward
Step 1
direction. (See
your index finger to open it, use a small, flat-blade screwdriver or other long,
narrow instrument to open the bale clasp. (See
Grasp the SFP module between your thumb and index finger and carefully remove
Step 2
it from the port. (See
Figure 2-19 Removing a Bale Clasp SFP Module with Your Index Finger
Cisco SN 5428-2 Storage Router Hardware Installation Guide
2-22
Figure
2-19.) If the bale clasp is obstructed and you cannot use
Figure
2-19.)
Chapter 2
Installing the SN 5428-2 Storage Router
Figure
2-20.)
OL-4797-01