Cisco SN 5428-2 Hardware Installation Manual page 34

Installing the SN 5428-2 Chassis
Figure 2
Note
To install the storage router in a rack, follow these steps:
Prepare for installation as follows:
Step 2
a.
b.
Remove two screws from the right side and two screws from the left side of the
Step 3
chassis. (See
Cisco SN 5428-2 Storage Router Hardware Installation Guide
2-8
Rack Rails
Front
If your mounting-post holes cannot accommodate the rack-post screws or
clips shipped with your storage router, you will need to supply other
screws or clips suitable for your equipment rack.
Measure the depth of the rack from the outside of the front mounting posts to
the outside of the rear mounting rails. The depth must be at least 23.5 inches
(59.7 cm) but not more than 34 inches (86.36 cm).
Measure the space between the inner edges of the left-front and right-front
mounting posts to ensure that the space for the chassis is at least 17.72 inches
(45 cm) wide.
Figure 2-3.)
Chapter 2 Installing the SN 5428-2 Storage Router
Rear
OL-4797-01